Guide To Paraffin Removal Oil Wells

Guide To Paraffin Removal Oil Wells

Because of their economic importance , to remove paraffin oil is considered to be critical. Already noted , thousands of wells have been abandoned prematurely . Sometimes even up to 90 % of the oil still present instance. Until it is removed, the material will slowly build , which will limit the flow of oil .

The first thing to do is analyze the composition of the oil from the well . These wells should not be any , but it should be those that paraffin is a suspected cause of declining production . It has been noted that different hydrocarbon compounds asphaltenes , can cause similar problems.

Bitumen is often found in the paraffin oil discovery. The resulting crude product must be tested so that it can be identified as the real question is what, if suspected to be true. Note that using the same method to control and removal of asphaltenes is not as effective in this process .

Most economical and simple method must be used to control and eliminate . Must be done before more complex and expensive method . Most of them are profitable interests more than anything else .

There is something called thermal method . It involves the introduction of an external heat source wellbore . It can melt causing output to decline. It is also the most widely used techniques , because of low cost , its simplicity .

Hot oil treatments can be carried out with the use of oil field services company. This process will involve circulating oil heating between upper and lower case one hundred and fifty to three hundred degrees Fahrenheit. This is a large diameter tube, wire line well bore and back , which is in the housing of the small pipes.

This wax oil well in the tubing deposit is melted . This may allow it to be lifted along with the production . Stored at the site of production is the use of this process . It is heated , and then pumped into the boiler to be installed in the truck pump contractor delivered to the site .

After treatment , you should regularly review and assess productivity. Thermal grease should be done to restore the production of the work significantly . Whenever there is decline , it should be repeated again .